Model: 300M Hotel 220V into the wall WIFI wireless network signal amplifier Smart socket relay AP panel
Time to market: 2019
Source category: Spot
Transmission rate: 300M
Coverage: 100 meters
Wireless standard: IEEE 802.11b/g/n mixed mode
This product is directly connected to the live and neutral lines. Connect the fire line to L and the neutral line to N. It can be installed in all locations where a Type 86 socket can be installed. If there is no wire in the socket position, you can drill the hot wire from the side of the socket.
It does not need to be equipped with a POE switch of the specified model as the POE version of the router.
Our routers can be connected in two ways: network cable connection and WIFI connection.
1. Connect the network of the switch or router through the network cable. You can set all routers to be in the same LAN. At this time, the wireless of a single router is unified as the wireless signal of the primary router.
2. Through the wireless WIFI signal connection, the router can connect through the wireless WIFI signal, as long as one of them is connected to the Internet, it can drive other routers to connect to the Internet. This type of Internet access is not connected through the network cable. All routers are separate WIFI signals and are not in the same LAN.
The router settings are very simple, very power-up, and then search the AP's wireless WIFI signal through the phone or computer, and then log in to set. The IP, account, and password set on the panel are on the back of the panel AP.
Note: The wall wireless router panel requires a network cable and a power cable for the installation location. Please reserve the network cable and power cable in advance. (If you do not reserve a power cable beforehand, you can connect the power cable from the power socket to the bottom box of the installation panel. Yes)